SKU: TTLRG-KEC0101R
MPN: KEC0101R
R&G KEC0101R Race Series Engine Case Cover Kit Honda CBR1000RR /SP/ SP2 '17-'19

R&G Racing's KEC0101R Race Series Engine Case Cover Kit is made specifically for Honda CBR1000RR /SP/SP2 (2017-2019).

This R&G Race Series engine case cover kit is designed to provide the highest level of protection for the expensive OEM cases in the event of a fall or spill. Hearty 4mm Polypropylene yields exceptional impact absorption and abrasion resistance. These premium Race Series case covers beef up the armored performance with the addition of replaceable slider pucks at the impact face for even greater prevention of wear through. After a fall or slide, just the slider puck itself can be replaced to restore full protective capabilities in only a few minutes. The Race Series cover kit is strongly advised for track day warriors and street riders as well since this somewhat inexpensive investment can save some serious money versus replacement of the costly magnesium case covers.

Mounting is painless as the original bolt holes can be reused with the provided replacement hardware without the need to perform any modifications. The R&G covers fit directly over the originals without the need to replace any gaskets or even spill a drop of oil. Total installation time is less than 5 minutes. Install the R&G Race Series engine case cover kit and ride into the sunset with confidence knowing your CBR is securely protected.

Features:

• Complete protection for the vulnerable & expensive OEM engine case covers
• Outstanding reduction in risk for breaking or wearing through the engine case covers in a fall or slide
• Stout 4mm Polypropylene construction is naturally impact absorbing & abrasion resistant
• Top of the line Race Series enhances protection with the addition of a replaceable slider puck at the impact face
• The replaceable slider puck further increases slide resistance & protection against wear through
• Unlike case sliders this case cover provides superior protection from top to bottom of the original case cover
• Just the slider puck itself can be replaced after a small spill to restore maximum protection in only minutes
• Fits directly over the OEM magnesium case covers
• Installation is simple & easy with the use of factory mounting holes & extended replacement hardware
• Gasket replacement or loss of oil is not needed during installation
• Approved by the AMA & used by BSB (British Superbike) race teams & California Superbike School

Includes:

• Right side R&G Race Series engine case cover TTLRG-ECC0236R
• Left side R&G Race Series engine case cover TTLRG-ECC0235R
• Mounting hardware
• Installation instructions